Fluid Plate Assembly Technical Data; Control Center Assembly Technical Data - Graco PrecisionSwirl Instructions-Parts List Manual

Fluid Plate Assembly Technical Data

Mounting dimensions and parts breakdowns for the fluid plate assemblies are in the installation section of this
manual.
Regulator Manual
Weight - No Flow Meter
Weight - Helical
Weight - Coriolis Flow Meter
Fluid Port Inlet
Fluid Port Outlet
Maximum Fluid Working Pressure*
Air Supply
Maximum Air Working Pressure
Minimum Air Working Pressure
Fluid Operating Temperature
Minimum Flow Rate - Helical
*Maximum system pressure depends on dispense valve.
Air outlets, open and close to dispense valve
Electric Power Requirements
Power Supplied to Dispense Valve Solenoid(s)
Fluid Specifications
Ambient Air Temperature Range

Control Center Assembly Technical Data

Voltage
Phase
Frequency
Full Load Current
Fuse Rating
Control Box Weight
3A2098S
Cartridge Regulator
308647
25.5 lb (11.6 kg)
40 lb (18 kg)
20 lb (9 kg)
Helical: 3/4 in. npt(f)
1/2 in. npt(f)
See Models on page 4
1/4 in. npt(f)
100 psi (0.7 MPa, 7.0 bar)
60 psi (410 kPa, 4.1 bar)
Ambient 40° - 120°F (4° - 50°C)
Ambient 190 cc/min
100 - 240 Vac Assemblies
100-240 Vac
1
50-60 Hz
1.4 A
250 Vac, 2.5A T
25.5 lbs (11.6 kg)
Mastic Regulator
307517
33 lb (15 kg)
48 lb (22 kg)
N/A
3/4 in. npt(f)
3/4 in. npt(f)
See Models on page 4
1/4 in. npt(f)
100 psi (0.7 MPa, 7.0 bar)
60 psi (410 kPa, 4.1 bar)
Heated 40° - 400°F (4° - 204°C)
Ambient 40° - 120°F (4° - 50°C)
Heated 190 cc/min
Ambient 190 cc/min
5/32 in. (4 mm) tube fittings
24 Vdc or 100-240 Vac
24 Vdc
For use when dispensing fluids that meet at least one of
the following conditions for non-flammability:
• The fluid has a flash point above 140° F (60° C) and a
maximum organic solvent concentration of 20% by
weight, per ASTM Standard D93.
• The fluid does not sustain burning when tested per
ASTM Standard D4206 Sustained Burn Test.
40° to 120°(4° to 50°C)
24 Vdc Assembly
24 Vdc
---
---
4.0 A
125 Vac, 4A F
Technical Data
149