Graco PrecisionSwirl Instructions-Parts List Manual page 54

Operation
Typical Job Cycle Chart
NOTE: Swirl can be turned on at any point inside of or
outside of a job. Allow time for the swirl to reach desired
RPM. If possible, verify Swirl speed through the
automation interface prior to opening the dispense
valve.
NOTE: A 50ms delay is suggested between each
signal.
NOTE: Dispense Complete must be strobed, not held
high in order to avoid an advisory.
Automation Inputs (PCF Outputs)
Dispense Ready
Dispenser (Fluid Plate) No Alarm
Dispenser (Fluid Plate) No Error
Dispenser (Fluid Plate) In Process
Volume OK
Automation Outputs (PCF Inputs)
Style Bits
Style Strobe
Dispense Valve X On
Dispense Complete
PCF State
Regulator Active (Precharge = 0)
Dispense Valve X Open
54
First Job Second Job
3A2098S