Graco PrecisionSwirl Instructions-Parts List Manual page 117

Fluid Plate x, Screen 1
This screen displays the current dispense control mode
used, the current pressure, and the current style being
dispensed. It also displays the target dispense volume,
the actual dispense volume, and the requested
dispense volume.
From this screen users can adjust the bead scale and
enter maintenance mode. Press
change the bead scale. Press
maintenance mode.
Current Dispense
Control Mode
Command Voltage
(Displays only when
Command Cable or Gate-
way is selected as the
Command Value Source;
see Fluid Plate Setup
Screens, page 111.)
Current Command
Value
Bead Scale
Quickly adjust pres-
sure/flowrate from this
screen
Active Style
3A2098S
and to
to enter
Inlet Pressure
(non-heated systems)
Progress Bar
Appendix A - Advanced Display Module (ADM)
The PCF system has two operating modes:
• Dispense mode – enables the module to begin
dispensing when it receives a command from the
automation unit.
• Maintenance mode – enables the module to begin
dispensing when the user presses the manual
dispense button. Dispense parameters and duration
depend on the selected control.
Dispensing continues for as long as the manual
dispense button
Volumes
is pressed.
Outlet Pressure
Flow Rate
(systems with flow
meters)
Active Dispense
Valves
Associated Swirl
Dispensers
117