Styles - Graco PrecisionSwirl Instructions-Parts List Manual

Operation

Styles

The PCF system has the ability to handle up to 256
styles, depending on the selected option.
NOTE: The number of available styles depends on the
fluid plate configuration. See Models on page 4. Style 0
is specified for purging only.
For each style, an independent target volume and
tolerance can be configured. This allows for job-related
errors and logs to be evaluated for each style. The style
is read at the beginning of a job and cannot be changed
until the next job.
PCF reads in the styles via the Gateway interface. For
detailed interface information, see Appendix B - Dis-
crete Gateway Module (DGM) Connection Details on
page 121, and Appendix C - Communications Gate-
way Module (CGM) Connection Details on page 128,
as applicable.
To setup a style:
1. Navigate to Fluid Plate x, screen 8.
2. Press to access the style setup fields.
F . 37
IG
50
3. Enter the style number in the Style field.
4. Enter Style Name:
a. Press while in the Style Name field to
display the Keyboard screen.
F . 38
IG
b. Use the arrow buttons on the ADM to scroll
through each letter. Press
in the style name field. See Keyboard Screen,
page 114, for further details.
c. Press to accept the new value.
5. Enter the target volume in the Volume field, and the
tolerance percentages in the Low and High
Tolerance fields.
6. Enter precharge mode and parameters. See
Precharge Modes beginning on page 51.
7. Press to exit edit mode.
to enter a letter
3A2098S