Bridge - D-Link DSR-150 User Manual

Section 5 - Connect to the Internet
When Bridge Mode routing is enabled, the first physical LAN port and secondary WAN/DMZ (port 2) interfaces
are bridged together at Layer 2, creating an aggregate network. The other LAN ports and the primary WAN
(WAN1) are not part of this bridge, and the router asks as a NAT device for these other ports. With Bridge mode
for the LAN port 1 and WAN2/DMZ interfaces, L2 and L3 broadcast traffic as well as ARP / RARP packets are
passed through. When WAN2 receives tagged traffic the tag information will be removed before the packet is
forwarded to the LAN port 1 interface.
Note: Bridge mode option is available on DSR-500 / 500AC /1000 / 1000AC routers only.
1. Click Network > Internet > Routing.
2. Complete the fields from the table below and click Save.
Field
Routing Settings
Bridge Interface IP
Address
DMZ Interface IP
Address
Subnet Mask
NAT with WAN1
Save
D-Link DSR-Series User Manual
Select Bridge.
Enter the bridge interface IP address.
Enter the DMZ interface IP address.
Enter the subnet mask.
Toggle ON to turn NAT on WAN1 or OFF for classical.
Click to save and activate your settings.

Bridge

Description
52