Spillover - D-Link DSR-150 User Manual

Section 5 - Connect to the Internet
1. Click Network > Internet > WAN Mode.
2. Complete the fields from the table below and click Save.
Field
WAN Mode
Load Balance
WAN Health Check
Retry Interval is
Failover After
Load Tolerance
Max Bandwidth
Save
D-Link DSR-Series User Manual
Select Load Balancing from the drop-down menu.
Select Spillover Mode.
• DNS lookup using WAN DNS Servers: DNS Lookup of the DNS Servers of the primary link is used to
detect primary WAN connectivity.
• DNS lookup using DNS Servers: DNS Lookup of the custom DNS Servers can be specified to check the
connectivity of the primary link.
• Ping these IP addresses: These IP's will be pinged at regular intervals to check the connectivity of the
primary link.
Enter the time in seconds to initiate the WAN health check. Default is every 30 seconds.
Enter the number of failures before the router will enable the failover process.
Enter the percentage of bandwidth after which the router switches to the secondary WAN.
This sets the maximum bandwidth tolerable by the primary WAN for outbound traffic.
Click to save and activate your settings.

Spillover

Description
48