Pptp Client - D-Link DSR-150 User Manual

Section 7 - VPN
Path: VPN > PPTP VPN > PPTP Client
PPTP VPN Client can be configured on this router. Using this client you can access remote network which is
local to PPTP server. Once client is enabled, the user can access Status > Active VPNs page and establish PPTP
VPN tunnel clicking Connect.
To configure the router as a PPTP VPN client:
1. Click VPN > PPTP VPN > PPTP Client tab.
2. Toggle Client to ON and complete the fields in the table below.
Field
Client
Server IP
Remote Network
Remote Netmask
Username
Password
MPPE Encryption
Idle Time Out
Auto Connect
Time
Save
Note: When the PPTP Client configuration is correctly saved and the PPTP server is up, the tunnel initiation starts
automatically.
D-Link DSR-Series User Manual

PPTP Client

Toggle to ON to enable PPTP client.
Enter the IP address of the PPTP server you want to connect to.
Enter the remote network address. This address is local for the PPTP Server.
Enter the remote network subnet mask.
Enter your PPTP user name.
Enter your PPTP password.
Toggle to ON to enable Microsoft Point-to-Point Encryption (MPPE).
Enter the amount of time (in seconds) that you will disconnect from the PPTP server when idle.
Enable or disable the Auto Connect feature.
Enter the reconnect time. If the client is disconnected from the server, then it will try to connect to the
server after the specified time.
Click Save to save and activate your settings.
Description
122