D-Link DSR-150 User Manual page 212

Section 8 - Security
3. Complete the fields from the table below and click Save.
Field
Name
Enable
Protocol
Interface
Outgoing (Trigger) Port
Range
Incoming (Response) Port
Range
Save
4. Click Security > Firewall > Dynamic Port Forwarding > Application Rules Status tab to see a list of
rules and their status. This page lists the application rules containing status, open ports, and expiry
time for a particular rule.
Field
LAN / DMZ IP Address
Open Ports
Time Remaining (Sec.)
D-Link DSR-Series User Manual
Enter a name for your rule.
Toggle to ON to activate the rule.
Select TCP or UDP.
Select either LAN or DMZ.
Enter the start and end trigger port range.
Enter the port range to open.
Click to save your settings.
It displays the internal network IP address that triggered the application rule to be active, and
resulted in response ports being opened.
It displays the incoming response ports that have been opened through this firewall based on the
internal devices request.
It displays the time in seconds for which the open ports will allow external traffic. This time is reset
whenever traffic is sent from the LAN / DMZ out on the trigger ports.
Description
Description
198