Access Server Client - D-Link DSR-150 User Manual

Section 7 - VPN
To configure the router as an OpenVPN access server client:
1. Click VPN > OpenVPN > OpenVPN Settings.
2. Toggle OpenVPN to ON and complete the fields in the table below.
Field
Mode
Port
Private Tunnel Client
Configuration
Enable Private Tunnel
Email Address
Password
VPN Cluster
Auto Connect
Interval
Upload Status
File
Save
D-Link DSR-Series User Manual

Access Server Client

Select Access Server Client.
Enter the port number on which openvpn server (or Access Server) runs.
It is applicable only in OpenVPN Access Server Client mode.
This feature connects to www.privatetunnel.com which provides a secured access connectivity.
Reachability to www.privatetunnel.com is required. This option is disabled by default.
Enter an email address registered with www.privatetunnel.com. Applicable only in OpenVPN Access
Server Client mode with Private Tunnel support enabled.
Enter a password. It can contain alphanumeric characters.
Select the type of VPN cluster. Applicable only in OpenVPN Access Server Client mode with Private
Tunnel support enabled.
Enabling this field allows user to enter time interval at which device should try connecting to the server.
Note: You can also Connect or Disconnect to the server on the following page: Status > Network Information >
Active VPNs > OpenVPN Connections, by right clicking the Connection Status.
Time interval at which device should try connecting to the server. It ranges from 1 minute to 60 minutes.
Displays if a configuration file has been uploaded.
Click Browse and locate the configuration file. Click Open and then click Upload.
Click Save to save and activate your settings.
Description
140