Tunnel Mode - D-Link DSR-150 User Manual

Section 7 - VPN
Path: VPN > IPSec VPN > Tunnel Mode
When tunnel mode is selected, you can enable NetBIOS and DHCP over IPSec. DHCP over IPSec allows this router
to serve IP leases to hosts on the remote LAN. You can also define a single IP address, a range of IPs, or a subnet
on both the local and remote private networks that can communicate over the tunnel.
The router allows full tunnel and split tunnel support. Full tunnel mode just sends all traffic from the client across
the VPN tunnel to the router. Split tunnel mode only sends traffic to the private LAN based on pre-specified client
routes. These client routes give the client access to specific private networks, thereby allowing access control
over specific LAN services.
1. Click VPN > IPSec VPN > Tunnel Mode.
2. Complete the fields in the table below and click Save.
Field

Tunnel Mode

Start/End IP Address
Primary/Secondary
DNS
Primary/Secondary
WINS
Save
D-Link DSR-Series User Manual
Tunnel Mode
Select either Full Tunnel or Split Tunnel.
Enter the starting and ending IP addresses.
Enter the primary and secondary DNS server addresses.
Enter the primary and secondary WINS server addresses.
Click Save to save and activate your settings.
Description
112