Wan3 (3G Internet) - D-Link DSR-150 User Manual

Section 5 - Connect to the Internet
Path: Network > Internet > WAN3 Settings
This router supports the use of 3G Internet access. Cellular 3G internet access is available on WAN3 via a 3G USB
modem for DSR series. The cellular ISP that provides the 3G data plan will provide the authentication requirements
to establish a connection. The dial Number and APN are specific to the cellular carriers.
settings are configured and saved, navigate to the WAN status page (Setup > Internet Settings > WAN3 Status)
and Enable the WAN3 link to establish the 3G connection.
Note: WAN3 (3G Internet) is available only in DSR-1000AC.
Field
Reconnect Mode
Maximum Idle Time
User Name
Password
Dial-in Number
Authentication Proto-
col
APN Required
APN
DNS Server Source
Primary DNS Server
Secondary DNS Server If you selected "Use These DNS Servers", enter the secondary DNS server IP address.
MTU Size
Custom MTU
D-Link DSR-Series User Manual

WAN3 (3G Internet)

Some ISPs may require you to pay for usage time. Select On Demand if this is the case. This will have the
router connect to the Internet only when you initiate an Internet connection. Select Always On to have
the router stay connected to the Internet.
Enter the idle time in minutes before the router disconnects from the Internet (On Demand only).
Enter your 3G account user name.
Enter your 3G account password.
Enter the phone number to access your Internet.
Select one of following protocols from the drop-down menu: None, PAP or CHAP.
Toggle to ON if your ISP requires APN to connect.
Enter the APN (Access Point Name) provided by the ISP.
Select either Get Dynamically from ISP or Use These DNS Servers to manually enter DNS servers.
If you selected "Use These DNS Servers", enter the primary DNS server IP address.
Select to use the default MTU value (1500) or select Custom to enter your own value.
Enter a MTU value to optimize performance with your ISP.
Description
Once the connection type
43