L2Tp Vpn; L2Tp Server - D-Link DSR-150 User Manual

Section 7 - VPN
Path: VPN > L2TP VPN > L2TP Server
A L2TP VPN can be established through this router. Once enabled a L2TP server is available on the router for LAN
and WAN L2TP client users to access. Once the L2TP server is enabled, PPTP clients that are within the range of
configured IP addresses of allowed clients can reach the router's L2TP server. Once authenticated by the L2TP
server (the tunnel endpoint), L2TP clients have access to the network managed by the router.
The range of IP addresses allocated to L2TP clients can coincide with the LAN subnet. As well the L2TP server
will default to local L2TP user authentication, but can be configured to employ an external authentication server
should one be configured.
To create a L2TP VPN server:
1. Click VPN >L2TP VPN > L2TP Server.
2. Complete the fields in the table below and click Save.
Field
Enable L2TP Server
L2TP Routing Mode
Starting/Ending IP Address
IPv6 Prefix
IPv6 Prefix Length
Authentication
Authentication Supported
Secret Key
Idle TimeOut
Save
D-Link DSR-Series User Manual

L2TP VPN

L2TP Server

Select either IPv4 or IPv6.
Select either NAT or Classical.
Enter the IP address range to assign your L2TP clients.
If you selected IPv6, enter the IPv6 prefix.
If you selected IPv6, enter the IPv6 prefix length.
Select the authentication type from the drop-down menu.
Toggle which type of authentication you want to enable to ON.
Enables/Disable support for Secret Key and enter Secret Key if support is enabled.
Enter the amount of time in seconds that the connection will disconnect when idle.
Click to save your settings.
Description
124