Wireless Settings; Access Points - D-Link DSR-150 User Manual

Section 6 - Wireless Settings
The Wireless Network Setup Wizard is available for users new to wireless networking. By going through a few
configuration pages you can enable a Wi-Fi™ network on your LAN and allow supported 802.11 clients to connect
to the configured Access Point. To run the wizard, refer to "#6 Wireless Network Setup" on page 12.
Path: Wireless > General > Access Points
This router has an integrated 802.11n/ac radio that allows you to create an access point for wireless LAN clients.
The security/encryption/authentication options are grouped in a wireless Profile, and each configured profile
will be available for selection in the AP configuration menu. The profile defines various parameters for the AP,
including the security between the wireless client and the AP, and can be shared between multiple APs instances
on the same device when needed.
Up to four unique wireless networks can be created by configuring multiple "virtual" APs . Each such virtual AP
appears as an independent AP (unique SSID) to supported clients in the environment, but is actually running on
the same physical radio integrated with this router.
Note: Profiles may be thought of as a grouping of AP parameters that can then be applied to not just one but multiple
AP instances (SSIDs), thus avoiding duplication if the same parameters are to be used on multiple AP instances or SSIDs.
To add, edit, or delete an access point entry:
1. Click Wireless > General > Access Points.
2. Right-click a current entry and select Edit or Delete. To add a new entry, click Add New Access Point.
D-Link DSR-Series User Manual

Wireless Settings

Access Points

93