Configure Dhcp Server - D-Link DSR-150 User Manual

Section 3 - Basic Configuration
To change the DHCP settings of the router, follow the steps below:
1. Log in to the router.
2. Click Network > LAN > LAN Settings. The LAN Settings page will appear.
3. From the DHCP Mode drop-down menu under DHCP Setup, select None (disable), DHCP Server
(enable), or DHCP Relay.
Note: DHCP Relay will allow DHCP clients on the LAN to receive IP address leases and corresponding
information from a DHCP server on a different subnet. When LAN clients make a DHCP request it will be
passed along to the server accessible via the Relay Gateway IP address you enter.
4. If enabled, fill in the following fields:
Field
Starting IP Address
Ending IP Address
Default Gateway
Domain Name
Lease Time
Configure DNS/WINS
5. Click Save at the bottom of the page.
D-Link DSR-Series User Manual

#3 Configure DHCP Server

Enter the starting IP address in the DHCP address pool. Any new DHCP client joining the LAN is
assigned an IP address within the starting and ending IP address range. Starting and ending IP
addresses should be in the same IP address subnet as the wireless controller's LAN IP address.
Enter the ending IP address in the DHCP address pool.
By default this setting is router's LAN IP address. It can be customized to any valid IP within the LAN
subnet, in the event that the network's gateway is not this router. The DHCP server will give the
configured IP address as the Default Gateway to its DHCP clients.
Enter a domain name.
Enter the time, in hours, for which IP addresses are leased to clients.
Toggle to On and enter DNS and/or WINS server IP address(es).
Description
7