Switch Setting; Auto Refresh - Mitsubishi Electric MELSEC-Q Series User Manual

7.1.2

Switch setting

(1) Setting method
Open the "Switch Setting" window to make the setting.
Project window  [Intelligent Function Module]  Module name  [Switch Setting]
Item
Number of
transmission points
setting
7.1.3

Auto refresh

Data in the buffer memory is transferred to a specified device.
With this setting, reading data with a program is not required.
(1) Setting method
Open the "Auto Refresh" window.
1.
Start "Auto Refresh" on the project window.
Project window  [Intelligent Function Module]  Module name  [Auto Refresh]
2.
Click the item to set. Then enter the device where auto refresh is performed.
54
Setting value
64 Points (input: 32 points, output: 32 points)
128 Points (input: 64 points, output: 64 points)
256 Points (input: 128 point, output: 128 points)
512 Points (input: 256 points, output: 256 points)
Description
Set the number of transmission points.
One transmission cycle time is determined by
setting the number of transmission points. (
Page 29, Section 3.2.3 (1))