Download  Print this page

When Connecting A Module To A Head Module - Mitsubishi Electric MELSEC-Q Series User Manual

Melsec-q/l anywireaslink master module.
Hide thumbs

Advertisement

9.3.2

When connecting a module to a head module

This section describes a system configuration and a program example for when connecting the LJ51AW12AL to a
head module.
For the head module, refer to the following.
 MELSEC-L CC-Link IE Field Network Head Module User's Manual
(1) System configuration
Master station (station No.0)
QJ71GF11-T2
(X/Y00 to X/Y1F)
Ethernet cable
(1000BASE-T)
Network No.1
(2) Programming conditions
The input signals of the input ASLINKER, stored in Input information area (Un\G0 to Un\G15) of the master
module connected to the head module, are batch-transferred to the device data of the CPU module.
Moreover, the device data of the CPU module is batch-transferred to Output information area (Un\G4096 to
Un\G4111) of the master module connected to the head module, and the output signals of the output ASLINKER
are transmitted.
(3) LJ51AW12AL operation setting
(a) Settings on the master station
1.
Create a GX Works2 project.
For "Series", select "QCPU (Q mode)". For "Type", select the CPU module to use.
[Project]  [New]
Intelligent device station (station No.1)
LJ72GF15-T2
LJ51AW12AL (X/Y1000 to X/Y101F)
CHAPTER 9 PROGRAMMING
AnyWireASLINK terminating unit
LED1
LED2
Output ASLINKER
(address: 0)
Sensor switch 1
Sensor switch 2
Input ASLINKER
(address: 0)
9
87

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric MELSEC-Q Series

   Related Content for Mitsubishi Electric MELSEC-Q Series

This manual is also suitable for:

Qj51aw12alMelsec-l seriesLj51aw12al

Comments to this Manuals

Symbols: 0
Latest comments: