System Using The Lj51Aw12Al; When Using A Module In The Ordinary System Configuration - Mitsubishi Electric MELSEC-Q Series User Manual

9.3

System Using the LJ51AW12AL

9.3.1

When using a module in the ordinary system configuration

In an ordinary system configuration using the LJ51AW12AL, programs of the QJ51AW12AL can be used. Make
settings as instructed in this section and follow the program example in Page 77, Section 9.2.1 (5).
(1) LJ51AW12AL operation setting
(a) PLC parameter setting
Following the program example of the QJ51AW12AL, change the setting for I/O assignment of the built-in I/O
function. Using "I/O Assignment" of "PLC Parameter", set to I/O assignment not used in the system.
The following is an example of "I/O Assignment" for when the L02CPU is used.
If using an LCPU with the built-in CC-Link function, set the I/O assignment of the built-in CC-Link function to
"0000", and set the start I/O number setting of the built-in I/O function to I/O assignment not used in the system.
(b) Setting the number of transmission points
1.
Add LJ51AW12AL to a project in GX Works2.
Project window  [Intelligent Function Module]  Right click  [New Module]
CHAPTER 9 PROGRAMMING
85
9