Mitsubishi Electric MELSEC-Q Series User Manual page 33

(b) Output response delay time
The figure below shows the time between the CPU module device turning on/off and a signal output from the
slave module turning on/off.
The output response delay time is the total of 1) to 5) in the following figure.
Slave module
AnyWireASLINK
CPU module
No.
Processing time on the programmable
1)
controller
2) Processing time on the master module
3) Transmission time
4) Processing time on the slave module
5) Output response time on the slave module
(4) Parameter access response time
The parameters of the AnyWireASLINK provide the monitoring information of the slave module or the entire
system and the setting information of the slave module.
Parameter data are synchronized between the buffer memory of the master module and the slave module at a
cycle different from that of the I/O data.
Use the following calculation formulas to obtain the parameter access response time.
[Update interval time of an automatically updated parameter]
Number of AnyWireASLINK connection IDs  transmission cycle time  3
[Time required for reading a parameter]
Number of target IDs  transmission cycle time  27
[Time required for writing a parameter]
Number of target IDs  transmission cycle time  39
1) Processing time on the
programmable controller
Description
CHAPTER 3 SPECIFICATIONS
5) Output response time
on the slave module
4) Processing time on the
slave module
3) Transmission time
2) Processing time on the
master module
Required time
Sequence scan time
0.6ms
Transmission cycle time  2
The transmission cycle time differs depending on the number
of transmission points. ( Page 29, Section 3.2.3 (1))
Approx. 0.04ms (The time differs depending on the slave
module.)
Refer to the manual for the slave module connected to the
system or the device connected to the slave module.
Output Output Output
31
3