General Safety Instructions And Warnings; Intended Use - Moog MSD Operation Manual

Safety
moog
ID no.: CA65642-001 06/2018
2.3

General safety instructions and warnings

DANGER! Risk of injury due to electrical power!
• Carelessness will result in serious injuries or death.
Follow safety instructions and warnings in this document and on the device.
WARNING! Risk of injury due to electrical power!
• Carelessness may result in serious injuries or death.
Follow safety instructions and warnings in this document and on the device.
CAUTION! Risk of injury or damage to the device due to incorrect operation!
• Carelessness may result in minor injuries or
damage.
Follow safety instructions and warnings in this document and on the device.
WARNING! Risk of injury due to hot surfaces and components!
• Carelessness may result in serious burns.
Electronic components may become hot during operation!
Follow safety instructions and warnings in this document and on the device!
Caution! Damage due to electrostatic discharge!
• Electrostatic discharge can destroy components.
Do not touch electronic components and contacts!
Follow safety instructions and warnings in this document and on the device!
DANGER! Risk of injury due to rotating parts on the motor!
• Carelessness will result in serious injuries or death.
Follow safety instructions and warnings in this document.
Pay attention to special safety instructions and warnings that are given here in the document before a
specific action and that warn the user about a specific hazard!
AC-AC Single-Axis System Operation Manual MSD Servo Drive
NOTE:
The pictograms may also be used on their own with the signal word, e.g.
in the connection diagrams, however they have the same function as in the
complete warning.
DANGER WARNING CAUTION
2.4

Intended use

Our devices are components intended for stationary electrical systems and machines in
the industrial and commercial sector.
Machinery Directive 2006/42/EC
The devices conform to the
Tested and certified according to applicable standards (see declaration of conformity in
chapter 2.8)
When installed in machines it is prohibited to start up intended operation until it has
been ascertained that the completed machine fully complies with the provisions of the
Machinery Directive (2006/42/EC); compliance with IEC/EN 60204 is mandatory.
Starting up intended operation is only permitted on compliance with the
2014/30/EU.
The devices meet the requirements of the harmonised product standard
IEC/EN 61800-5-1.
You will find information on the installation of your device in chapter "3 Mechanical
installation".
12
EMC Directive