Programming Frequency Band Scan - Codan 8525B Series Handbook

Using the receiver in scan mode

Programming frequency band scan

The band scanning facility enables the Radiophone to scan between two programmed
frequencies. You can program the frequency bands to suit your needs.
Up to 30 bands can be programmed into the Radiophone, and stored between
channels P70 and P99.
There are two rates of scan available, fast and slow:
•
fast scanning changes the frequency in ten 1 kHz steps per second
•
slow scanning changes the frequency in ten 100 Hz steps per second.
Your Radiophone must be switched on before commencing this procedure.
Step Action... Display shows...
1. The following
buttons must be
pressed within
one second.
Press
Enter
then press any of
the Tune Rx
Frequency
buttons, example
1
Fast
then press
Scan
6-12
Remarks...
The Scan button
indicator flashes.
The next action must
start within 60 seconds.
F
Outback HF Radiophone