Codan 8525B Series Handbook page 92

Using the receiver in scan mode
Step Action... Display shows...
4. Press
Scan
5. Press
Enter
and then
Scan
within one
second.
Notes: If an error is made, the programming mode must be switched off (follow
step 5), and the procedure repeated.
If you try to program more than 15 entries, you will hear a single low-
pitched tone and the error message 'scan full' displays.
The channel entries can be reviewed while in the scan programming mode.
Use the channel and
channel in the scan program is indicated by 'prog' on the display (as shown
in step 4 above).
The scan program can be inhibited, refer to Setting up the scan mode on
page 6-3.
6-6
Remarks...
The channel is
programmed for
scanning.
Repeat this procedure
until all channels you
want to scan have been
programmed.
The channels you have
programmed are now
registered within the
transceiver.
buttons to scroll through the channels. Any
Outback HF Radiophone
q