Using The Receiver In Scan Mode - Codan 8525B Series Handbook

6. Using the receiver in scan mode

In the receiver scan mode your Radiophone is able to listen
into selected channels for transmitted signals. Once a signal
has been detected, the Radiophone holds that channel for a
pre-selected time before continuing with the scan. This is
determined at set-up.
In normal operating conditions, a maximum of 15 channels
can be programmed to be scanned in sequence for audio
(voice) signals. A maximum of 8 selective call channels can
also be included but must be programmed within the first
eight entries.
All displays in this section show examples of channel and
frequency numbers. You must insert your selected channel
and frequency numbers.
Outback HF Radiophone
q
6-1