Setting Up Tone Call - Codan 8525B Series Handbook

Setting up tone call

This procedure is similar to setting up selective call. Once in the set-up mode, you can
skip through the non-important steps by pressing the Enter button.
Step Action... Display shows...
1. To start the set-up
mode, hold down
Selective
Call
and press
On/Off
Press
2.
Enter
3. Press
Enter
4. Press
Enter
5. Press
Enter
Outback HF Radiophone
Using tone call
Remarks...
Hold the Call button
down for approximately
three seconds.
This turns the
Radiophone on, and into
the preamble set-up
mode.
This set-up is not
required.
This set-up is not
required.
This set-up is not
required.
This part of the
procedure allows you to
enter the tone calling
frequencies.
F
8-3