Siemens Sinamics G120 CU240E Operating Instructions Manual page 162

Functions
5.11 Operation in fieldbus systems
Note
The description provided in this manual uses the hardware listed above. Other similar
products not listed above can also be used.
Software components
Component
SIMATIC STEP 7
Drive ES Basic
Drive ES Basic is the basic software of the engineering system, which combines the drive
technology and Siemens controllers. The STEP 7 Manager user interface acts as a basis
with which Drive ES Basic is used to integrate drives in the automation environment with
respect to communication, configuration, and data storage.
Setting the PROFIBUS address of the frequency converter
Two DIP switch blocks are located on the Control Unit. The PROFIBUS address of the
frequency inverter is set using one of these. The DIP switch for the PROFIBUS address is,
depending on the firmware release, either located on the front of the CU below the operator
and display instrument (Operator Panel) or at the side of the CU.
Figure 5-18
Alternatively, the PROFIBUS address can be set via parameter P0918, although you should
only use this method if you cannot set the address via the DIP switches.
CAUTION
When the PROFIBUS address is changed, the Control Unit needs to be switched off and on
again to activate the new address. This must be carried out by switching the power supply
off and then on again, regardless of whether the interface is supplied by the power supply
for the converter or via its own 24 V power supply.
162
Type
V5.3 + SP3
V5.4
PROFIBUS DIP switches
Order no.
6ES7810-4CC07-0YA5
6SW1700-5JA00-4AA0
Operating Instructions, 08.10. 2008, t.b.d.
Qty
1
1
Frequency inverter