Managing Licenses - Zeiss CLARUS 500 Instructions For Use Manual

5 Configuration

5.6 Managing Licenses

NOTE
72 / 192
2. To automatically assign an IP address to the instrument, set
DHCP to Enabled. For a network with static IP addresses, set
DHCP to Disabled and enter the relevant network infor-
mation.
3. Under Network Drive Configuration, select Map....
4. Enter the network path for the shared folder you'd like to
connect to. The shared folder must be a root directory or a
subdirectory of a root directory.
5. Select an unused drive letter.
6. If a password is required for access to the shared folder, enter
the username and password. Otherwise, leave these fields
blank.
7. Select Map.
ð Successfully mapped drives are indicated with a check mark
in a green circle. To disconnect a network drive, select the
drive, then click Unmap.
5.6 Managing Licenses
Your instrument is shipped with the software license installed. The
instrument's software license and ten Review Station licenses are
provided with the instrument. You can install CLARUS® 500 review
software on (up to) ten computers to use as Review Stations.
After you install software on each Review Station, you must
activate a license for it.
If you return a license from a Review Station computer, you can
install and activate the software on a different Review Station
computer using the same license.
Only Administrators can complete this task.
Instructions for Use
CLARUS® 500
2660021171806 Rev. A 2019-01