Table of Contents
Advertisement
Replacing the stability foot
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Tilt the computer towards the front until the base is facing up.
2
Align the screw holes on the stability foot with the screw holes on the base of the computer and replace the two screws
(#6-32x6).
26
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the Area-51 Threadripper Edition R7 and is the answer not in the manual?
Questions and answers