Table of Contents
Advertisement
Replacing the drive-bay heat sensor cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Route the drive-bay heat-sensor cable through the slot on the chassis.
2
Align the tab on the drive-bay heat-sensor cable on the chassis.
3
Push the release tab on the drive-bay heat-sensor cable and press it into place.
4
Lay the chassis on the left side.
54
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
Advertisement
Table of Contents
