Replacing The Stability Foot; Procedure - Alienware Area-51 R3 Threadripper Edition Service Manual

Replacing the stability foot

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Tilt the computer towards the front until the base is facing up.
2 Align the screw holes on the stability foot with the screw holes on the base
of the computer and replace the two screws (#6-32x6).
3 Tilt the computer back to the upright position.
32
computer. After working inside your
After working inside your