Table of Contents
Advertisement
Replacing the right AlienFX side-panel connector
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Route the cable through the slot on the bracket and align the screw holes on the right AlienFX side-panel connector with
the screw holes on the bracket.
2
Replace the two screws (#6-32x6) that secure the right AlienFX side-panel connector to the bracket.
3
Align the screw hole on the right AlienFX side-panel connector assembly with the screw hole on the chassis.
4
Replace the screw (#6-32x6) that secures the right AlienFX side-panel connector assembly to the chassis.
5
Route the right AlienFX side-panel cable through the routing guides on the chassis.
6
Connect the cable that connects the right AlienFX side-panel connector to the I/O board. See
44
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
"I/O-board
components".
Advertisement
Table of Contents
