Table of Contents
Advertisement
Replacing the processor liquid-cooling assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
CAUTION: Incorrect alignment of the processor liquid-cooling assembly can damage the system board and
processor.
1
Apply thermal grease between the processor liquid-cooling assembly pump and the processor.
NOTE: The original thermal grease can be reused if the original processor and processor liquid-cooling are
reinstalled together. If either the processor or the processor liquid-cooling is replaced, use the thermal grease
provided in the kit to ensure that thermal conductivity is achieved.
2
Hold the processor liquid-cooling assembly pump in one hand and processor liquid-cooling assembly fan in another.
3
Align the processor liquid-cooling assembly pump over the processor, while holding the processor liquid-cooling assembly
fan outside the chassis and secure the processor liquid-cooling assembly pump.
4
Connect the processor liquid-cooling assembly fan and the processor liquid-cooling assembly pump-fan cable to the
connectors on the system board.
5
Align the screw holes on the processor liquid-cooling assembly fan with the screw holes on the chassis.
6
Replace the four screws (#6-32x6) that secure the processor liquid-cooling assembly fan to the chassis.
7
In sequential order as indicated on the processor cooling-assembly, tighten the captive screws that secure the processor
liquid-cooling assembly to the system board.
8
Connect the processor liquid-cooling assembly fan cable to the system board.
86
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
Advertisement
Table of Contents
