Table of Contents
Advertisement
Removing the stability foot
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Tilt the computer towards the front until the base is facing up.
2
Remove the two screws (#6-32x6) that secure the stability foot to the computer.
3
Lift the stability foot off the computer.
24
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
computer. After working inside your computer, follow the instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the Area-51 Threadripper Edition R7 and is the answer not in the manual?
Questions and answers