Removing The Drive-Bay Heat Sensor Cable; Prerequisites; Procedure - Alienware Area-51 Threadripper Edition R7 Service Manual

Removing the drive-bay heat sensor cable

WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in After working inside your
www.dell.com/regulatory_compliance.

Prerequisites

1 Remove the stability
2 Remove the left and right side-panels. See

Procedure

1 Lay the chassis on the right side. Locate the drive-bay heat-sensor connector (SENSOR2) on the system board. For more
information on the drive-bay heat-sensor connector, see
2 Disconnect the drive-bay heat-sensor cable from the system board.
3 Turn the chassis over.
4 Remove the cable through the slot on the chassis. Locate the drive-bay heat-sensor. See
52
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
foot.
"Removing the side
computer. After working inside your computer, follow the instructions
panels".
"system-board components".
"right view".