Autoimage Setup - Barco BARCOIQ GRAPHICS 200L Owner's Manual

Image 12-20
Image 12-21
There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch
between the two.

12.14AutoImage Setup

What can be done ?
Autoimage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the LCD panels.
Autoimage can adapt the image based on following data :
• Total pixels per line
• Start pixel
• Phase
• Contrast/brightness levels
Autoimage works only for data signals.
How to set up AutoImage?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select AutoImage setup (image 12-22)
5. Press ENTER
A dialogbox is displayed.
(image 12-23)
6. Use the arrow keys to select the desired item and press ENTER to activate or disactivate the item.
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
12. Installation menu
105