Table of Contents
Advertisement
4. Getting started
14
FREEZ
15
PIP
16
ENTER
17
Cursor keys
18
BACK
19
EFFECTS
20
PIP ADJUST
21
RC operating indication
22
IR receiver
Table 4-1
Diagnose LED's
LED1
LED2
LED3
4.3 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
-
When '0' is pushed in, the projector is switched off.
-
When '1' is pushed in, the projector is switched on
The projector starts in standby mode, LED3 is red.
Starting image projection.
1. Press Standby key once on the local keypad or on the remote control.
It may take about 30 seconds before image projection, i.e. no projection until the completion of several oper-
ations (software initialization, input scanning,...).
4.4 Lamp runtime
x
To generalize for the different projector types, x refers here to the maximum run time of the lamp.
Lamp runtime indication while running
Independently of the lamp mode, when the total runtime of an active lamp (lamp1 for example) is (x-30) hours or more, a warning
message will be displayed.
32
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
to confirm an adjustment or selection in the MENU.
On the local keypad the ENTER button additionally accesses the PIP window resize function
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
toolbar.
to leave the selected menu or item (go upwards to previous menu).
not yet implemented
allows to select a PiP window and change its configuration on screen
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
IR receiver
Green
cool down sequence: flickers 60 seconds after
switching to standby
IR acknowledgement
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
-
Red
rescue program (software error)
hardware error
standby
Advertisement
Table of Contents
