Table of Contents
Advertisement
3. Connections
Image 3-5
Component Video
In Component Video the term component describes a number of elements that are needed to make up the video
picture, these components are PR/Y/PB. A composite video signal on the other had contains all the information needed
for the color picture in a single channel of information
Which signals can be connected ?
Signals/Input BNC
RGBHV
1
RG
B
s
1
RGBS
Component
Beside the standard RGB, component and sync signals, the extended mode of the 5 Cable input makes pro-
cessing of additional signals possible. see 5 cable extended configuration, page 25
How to select a source on the 5 cable input ?
1. Press 1 on the RCU
Note: Another way for selecting this input is via Source on the local keypad or via the Menu
Component Video signals (PR/Y/PB)
Some interfaces use progressive output signals with a double line frequency of 32 kHz. The video decoder
used for the video signals is not appropriate for these signals since it can only handle 16 kHz signals. This
signal has therefore to be internally redirected, this is done in the Source selection menu by selecting Data on
BNC's instead of Component video and by selecting Cr/Y/Cb in the advanced settings of the Image file menu.
3.4 Composite Video Input
Input specifications
The Composite video input section is made of 1BNC input terminal.
1.0 Vpp ± 3dB
75
terminated
No loop through
1. data or video
20
R
G
R
G
R
G
s
R
G
PR
Y
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
B
H
B
H
-
B
B
S
-
PB
V
V
-
-
-
Advertisement
Table of Contents
