Barco BARCOIQ GRAPHICS 200L Owner's Manual page 84

9. Signal Menu
How to select a switching mode ?
1. Press MENU to activate the Toolbar
2. Press → to select the Signal item
3. Press ↓ to Pull down the Signal menu
4. Use ↑ or ↓ to select Switching mode
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the desired switching mode (image 9-2)
7. Press ENTER
A white bullet shows the active effect.
The next source switching will be done using the selected effect
Image 9-2
The Random mode will select a new switching mode at each source switching i.e. there will never be 2 suc-
cessive source switchings with the same effect.
The Seamless switching mode is not used in the Random mode.
Note on Fade in/out
In some cases, depending on the sources to be switched, the fade in/out effect is impossible or may not occur.
78 R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002