Startup Screen; Automatic Startup - Barco BARCOIQ GRAPHICS 200L Owner's Manual

12. Installation menu

12.9Startup screen

What can be done ?
When the startup screen is enabled, the identification screen is displayed for a few seconds at startup. This startup screen can also
be disabled.
How to enable/disable the Startup screen?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Startup screen (image 12-14)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired baudrate
7. Press ENTER
Image 12-14

12.10Automatic startup

What can be done ?
The automatic startup allows immediate restart of the projector after a power failure (breakdown).
The projector restarts at power resume and recovers the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
If the Automatic startup function is enabled one must be aware of the fact that it involves safety precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Automatic startup
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable/disable the automatic startup
7. Press ENTER
102 R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002