Sliderbox Position; Autoimage Setup - Barco iD PRO R600 Owner's Manual

6.9.7

Sliderbox position

What can be done ?
The sliderbox can be displayed anywhere on the screen, the position can be set in this menu.
How to reposition the sliderbox?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Sliderbox position
5. Press ENTER
A sliderbox is displayed. Use the 4 arrow keys to drag the box to the desired position. (image 6-115)
Image 6-115
There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch
between the two.
6.9.8

AutoImage Setup

What can be done ?
Autoimage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the LCD panels.
Autoimage can adapt the image based on following data :
• Total pixels per line
• Start pixel
• Phase
• Contrast/brightness levels
Autoimage works only for data signals.
How to set up AutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select AutoImage setup
5. Press ENTER
A dialog box is displayed.
(image 6-116)
6. Use the arrow keys to select the desired item and press ENTER to activate or disactivate the item.
R5976874 ID PRO R600/R600+ 21/09/2006
6. Advanced
93