Video Extended Configuration - Barco BARCOIQ GRAPHICS 200L Owner's Manual

3. Connections
Signals
RGBHV
RG B
S
RGBS
Component
S-Video
S-Video
Composite
Composite
Composite
Composite
Composite
Table 3-2
Extended configuration of the 5 cable input: the first column gives the possible signals, and the first row the 5 cable input connectors (+ the standard Video BNC).
How to set up the 5 cable extended configuration ?
1. Connect the video or S-video source to the desired BNC connector
Note: In some cases an adapter cable is required (image 3-13, image 3-14, image 3-15)
Image 3-13
Connecting an S-Video signal on the Vs &
Video BNC
Multiple video signals can not be visualized simultaneously since there is only one decoder. However, the
use of the optional Audio & video layer(3) allows to visualize up to 2 different video signals (in PiP mode, see
Introduction to PiP, page 68).
3.11.3 S-Video extended configuration
What can be done ?
Beside the standard luminance (Y) and chrominance (C) signals, the advanced capabilities of the S-Video input make treatment of
additional signals possible:
• 2 composite video signal may be connected.
Signals
Table 3-3
Extended configuration of the S-Video input: the first column gives the possible signals, and the first row the S-Video inputs pins.
26
R
R
R
R
PR
-
C
VIDEO
-
VIDEO
-
-
-
Image 3-14
Connecting an S-Video signal on the R & B
BNC
S-Video
Composite Video
Composite Video
Inputs
G B
G B
G B
S
G B
Y PB
- -
-
Y
- -
-
-
VIDEO
- -
- -
Image 3-15
Connecting composite Video signals on the
5 cable input
Y
Y
Video
-
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
H V
H V
- -
-
S
- -
-
C
- -
- -
- -
- -
-
VIDEO
- -
Inputs
C
C
-
Video
VIDEO
-
-
-
-
Y
-
-
-
-
VIDEO