Table of Contents
Advertisement
Image 11-19
There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch
between the two.
11.12AutoImage Setup
What can be done ?
Autoimage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the LCD panels.
Autoimage can adapt the image based on following data :
•
Total pixels per line
•
Start pixel
•
Phase
•
Contrast/brightness levels
Autoimage works only for data signals.
How to set up AutoImage?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select AutoImage setup (image 11-20)
5. Press ENTER
A dialogbox is displayed.
(image 11-21)
6. Use the arrow keys to select the desired item and press ENTER to activate or disactivate the item.
Image 11-20
R5976495 BARCOREALITY SIM 6 ULTRA MM 22102002
11. Installation menu
77
Advertisement
Table of Contents
