Show Native Resolution - Barco BARCOIQ GRAPHICS 200L Owner's Manual

7. Image Menu
Selecting Auto in case of a Video source may shrink the image horizontally
How to change the Aspect ratio ?
1. Press MENU to activate the Toolbar
2. Press → to select Image
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Aspect ratio
5. Press ENTER to confirm

7.4 Show native resolution

Graphics
Native resolution of the LCD panels = 1024 pixels x 768 pixels (4:3)
Reality
Native resolution of the LCD panels = 1366 pixels x 1024 pixels (4:3)
What can be done ?
The aim here is to always show the resolution of the source independently of the resolution of the LCD panels.
Depending on the type of projector the "show native resolution" function will handle the sources as follows:
Source
Name Ratio
xga
4:3
sxga
5:4
sxga+
4:3
uxga
4:3
Table 7-1
Show native resolution = ON in case of a Graphics and a Reality BarcoIQ projector
The Full screen representation function on the other hand forces to use the complete native resolution of the
LCD panels, see Full screen representation, page 99
How to enable the "Show native resolution" function?
1. Press MENU to activate the Toolbar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Show native resolution (image 7-4)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select On
7. Press ENTER
A white bullet shows the selection
58
Projected image
Resolution Ratio
1024x768 4:3
1280x1024 5:4
1400x1050 4:3
1600x1200 4:3
Resolution Particularities
Reality
1024x768 image centered +side
blanked
1280x1024 image centered +side
blanked
1400x1050 scroll image
1600x1200 scroll image
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
Particularities
Graphics
scroll image
scroll image
scroll image