Image Files Menu; Flowchart - Barco BARCOIQ GRAPHICS 200L Owner's Manual

11. IMAGE FILES MENU

Overview
•

Flowchart

• Load file
• Edit file
• Rename file
• Copy
• Delete
11.1Flowchart
Overview of the Image files menu
Image 11-1
Introduction to image files
An image files contains the main characteristics of a source (number of active lines,...). The projector's memory contains a list of
files corresponding to the most common sources, these are the standard files (file extension= *.s). When a new source corresponds
to one of these files, a custom file (file extension=*.C) is created and saved for future use.
When there is a little difference, the file can also be loaded and then edited until the source specs are reached.
The AutoImage function creates automatically the best suited image file (custom file) for a new source. Au-
toImage is used when:
- a new source is detected : AutoImage creates a new custom file which can always be edited if necessary.
- the AutoImage button on the RCU is pressed
AutoImage works only in full screen mode
If the AutoImage function does not succeed in finding a file and no file is loaded (load list is empty), which
means that the source is not displayed, then use the copy function, see Copy, page 92
Possible file manipulations
The possible file manipulations are :
R5976367 BARCOIQ GRAPHICS/REALITY 200L/300/400 10062002
11. Image files menu
87