Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
2.2.4.3.2 PPPoA and PPPoE Mode PING Results
After configuring, press F3 to start the test. As the test proceeds,
the test set displays an 'IN PROGRESS' message.
For PPP PING results there are three stages to the test:
• ROUTER: This stage identi-
fies the connection to the
Broadband Remote Access
Server or ISP.
• PPP: Identifies the account
with the ISP and ensures that
account verification (with
authentication enabled) is
established.
• PING represents the
connection/response to the
destination IP address.
Reflected in Figure 14 are these three stages:
• ROUTER
-
"PASS" means that the module has connected to the
router/broadband access server (ISP). The next step will
be to verify authentication.
-
"FAIL" means that no connection to the ISP is available.
• PPP
-
"PPP: in progress" means that the handshaking procedure
is currently in progress. A local IP address is not yet as-
signed, as indicated by all zeros for the LOCAL IP. If static
IP management were selected, the LOCAL IP entered in
the configuration screen would be used.
-
"PPP: PASS" means that the authentication handshaking
was successful and a local IP address has been assigned,
as displayed on the LOCAL IP line.
• PING
-
"PING:—" This stage has not begun yet. PING will begin
as soon as the PPP stage is completed.
-
"PING: in progress" means that the PING test is currently in
process. As soon as the module receives a response from
the destination, it will display 'PASS'. If the test set receives
no response from the destination, it will display 'FAIL'.
12:30:55
>LINK UP
4W STU-R<
ST:12:30:10
ET:00:00:45
LOCAL IP:004.008.022.001
DEST IP :002.003.004.005
PING TEST
ROUTER :
PASS
PPP
:
PASS
PING
:
IN PROGRESS
STOP
Figure 14
PPP PING Results Screen
Page 24 of 101
Advertisement
Table of Contents
