Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
2.2.5.1.2 OAM Cell Generation
This screen contains configura-
tion items for OAM cell genera-
tion.
Figure 17 OAM Cell Generation Screen
Configure the items in the left column under OAM TRANSMIT:
VPI
Options: 0–255
Enter the Virtual Path Identifier by using SHIFT and the number
keypad. See Section 2.2.5.1.1 for more information.
VCI
Options: 0–65535
Enter the Virtual Channel Identifier by using SHIFT and the num-
ber keypad. See Section 2.2.5.1.1 for more information.
GFC
Options: 0000–1111 (binary only), default 0000
Enter a value using SHIFT and the numeric keypad. Generic
Flow Control assists in the control of the flow of traffic. Used
only for UNI interfaces. It is primarily used to ease short-term
overload conditions (too many cells). As indicated in Figure 17,
it contains 4 bits. It is an ATM layer function. In real-life it is not
widely utilized, as the CLP (Cell Loss Priority indicator) does the
flow management job.
CLP
Options: 0 or 1
Enter a value for Cell Loss Priority by using SHIFT and the numeric
keypad. See Section 2.2.5.1.1 for more information.
TYPE
Options: F4SGAIS (F1), F4SGRDI (F2), F4SG_LP (F3), F4EEAIS
(more, F1), F4EERDI (more, F2), F4EE_LP (more, F3), F5SGAIS
(more, F1), F5SGRDI (more, F2), F5SG_LP (more, F3), F5EEAIS
(more, F1), F5EERDI (more, F2), F5EE_LP (more, F3)
Choose the type of OAM cell to transmit. Refer to Section
2.2.5.1.3 for definitions of OAM cell types.
12:03:43
>LINK UP
2W STU-R<
OAM CELL GENERATION
ST:
ET:
OAM TRANSMIT
OAM RECEIVE
VPI
:8
# Tx
:
-
VCI
:35
# Rx
:
-
GFC
:0000
# LOST :
-
CLP
:0
ROUNDTRIP(ms)
TYPE
:F5EE_LP
CUR:
-
#CELL
:1
AVG:
-
TIMEOUT:2
sec
MAX:
-
MIN:
-
STORE
PRINT
START
Page 30 of 101
Advertisement
Table of Contents
