Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
2.2.5.2 IP Features
These optional features provide advanced Internet connectivity
troubleshooting through detailed connection status, PING statis-
tics, and trace route. The menu screen contains the following:
• CONFIGURATION
• IP STATUS
• PING TEST
• TRACE ROUTE
• ECHO RESPONSE
2.2.5.2.1 Configuration
After turning up the link, select IP FEATURES > CONFIGURATION
from the main menu. This screen contains configuration items for
the IP connection. Enter the proper protocol used by the circuit,
as well as the necessary IP addresses.
CONNECT/DISC appears at either F3 or F4 depending on the
setting selected. Press CONNECT to start the connection pro-
cedure to the ISP. Press DISC to release the connection. Once
CONNECT is pressed; the connection will stay UP, if successful,
or DOWN if unsuccessful. In either case, press DISC to change
any of the configuration items.
MODE
Options: PROFILE (F1), LLC-BRG (F2), LLC-RTE (more, F1),
CLIPoA (more, F2), PPPoE (more, F1), PPPoA (more, F2)
Select the protocol mode for the PING test.
• PROFILE allows storing and retrieving of IP configurations,
see the subsection entitled Profile Setup.
• LLC-BRG refers to LLC-Bridge protocol. This follows RFC
1483 bridge encapsulation. It supports both static and dynamic
(DHCP) IP management.
•
LLC-RTE refers to LLC-Routed protocol. It supports only
static
IP addressing.
•
CLIPoA refers to Classical IP over ATM according to
RFC2225.
It only supports Static IP addressing.
• PPPoE refers to PPP over Ethernet, according to standard
RFC 2516 PPP over Ethernet. PPPoE supports both static
and dynamic IP addressing.
• PPPoA refers to PPP over ATM, according to standard RFC
2364, PPP over AAL5. PPPoA supports both static and dy-
namic IP addressing.
Note: The actual configuration settings displayed depend on the
selected MODE as seen in Figure 20:
Page 34 of 101
Advertisement
Table of Contents
