Pppoa And Pppoe Mode Setup; User Id - VeEX MTT-14B User Manual

MTT-14B e_Manual D07-00-083P RevA00

2.2.4.3 PPPoA and PPPoE Mode Setup

PPP (Point-to-Point Protocol) allows one or more user sessions
to tunnel across the link. This includes provisions for security
and protocol negotiations. The module supports two versions of
PPP: PPPoE (PPP over Ethernet) and PPPoA (PPP over ATM).
Refer to Section 4.1 for details on these protocols.
When selecting PPP, the network security and authentication
requires negotiation. Refer to the following figure:
11:50:50
>LINK UP
PING SETUP
MODE
ENCAPSULATION :AUTO
AUTHENTICATION:PAP
VPI
VCI
IP ADDRESS
DESTINATION IP:001.333.452.012

USER ID

: *******
PASSWORD : *******
PROFILE LLC-BRG
Figure 13 PPPoA PING Setup Screen
Configure these settings for PPPoA and PPPoE modes:
ENCAPSULATION
Options: LLC (F1), VC MUX (F2), AUTO (F3)
This refers to the Encapsulation method for carrying traffic over
AAL Type 5 over ATM.
• LLC: Logical Link Control based on IEEE standard 802.2. LLC
encapsulation is used when multiple protocol are encapsu-
lated over a single ATM Virtual Connection.
• VC MUX: This is used when only one protocol is carried over
a single ATM Virtual Connection.
• AUTO: Automatically detect the setting.
Note: When MODE is set for PPPoE, LLC is the only available
encapsulation method.
AUTHENTICATION
Options: PAP (F1), CHAP (F2), AUTO (F3)
The authentication layer ensures that only a valid device estab-
lishes a connection with the network. Choose the following:
4W STU-R<
:PPPoA
:8
:35
:DYNAMIC
START more
Page 21 of 101