Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
Press ENTER to select that character. The character will ap-
pear in the URL line. Repeat this until done then press STOP
(F3) to exit the character grid.
• If a mistake is made, press STOP (F3) and use
the incorrect character.
-
Press DELETE (F2) to delete the character.
-
Press INSERT (F1) to add a character to the left of the
selected character.
-
Press OVER (F1) to replace the selected character.
6. Press F4 to save and return to PING configuration.
#PINGS
Options: 1-999999; default is 10.
Select the number of PINGS to send. Use SHIFT, the number key-
pad and
to enter a number, or press F1 for continuous.
PING LEN
Options: 64-1500 bytes; default is 64.
Select the PING length to send. Use SHIFT, the number keypad
and
to enter a value.
PING/SEC
Options: 1-10; default is 1.
Select the number of PINGS to send per second from. Use SHIFT,
the number keypad and
When ready, press F4 to begin. Press again to stop. The follow-
ing is reported:
PING: result will indicate:
PING: –: The test hasn't been started.
PING: IN PROGRESS: The test is in process.
PING: PASS: At least 1 echo response has been received.
PING: FAIL: An echo response has not been received.
PING: NO DNS SERVER: The DNS server is unavailable.
PING: DNS LOOKUP FAILED: The IP address could not be
associated with the host name.
The bottom of the screen reports the statistics of the test:
Sent: Number of PINGS sent to the network.
Recv'd: Number of correct echo responses received.
Unreach: Number of echo responses with an unreach flag.
Missing: Number of echo responses missing.
Round Trip: Measure of the round trip delay in milli seconds.Crnt
(Current), Avg (Average) and Max/Min (Maximum and Minimum)
is reported.
to select
to enter a value.
Page 45 of 101
Advertisement
Table of Contents
