MTT-14B e_Manual D07-00-083P RevA00
2.2.3 Modem Control
This menu contains the following:
• LOOPBACK CONTROL
• SYSTEM SETTINGS
2.2.3.1 SHDSL System Loopback Control
08:39:57
>LINK UP
SHDSL SYSTEM LOOPBACK
STU-C
T
R
COMMAND :
STATUS
:
LOOP-DN STU-C C STU-R N
Figure 7 SHDSL System Loopback Screen
This screen displays a loopback graphic. It includes a COMMAND
line used to enter different types of loopback messages sent via
the EOC. They are:
LOOP-DN (F1): This will cause the COMMAND line to change to
LOOP-DN and the appropriate EOC message will be sent. The
STATUS line will report either SUCCESS or FAIL.
STU-C C (F2): Use this to loopback the STU-C, facing the cus-
tomer. This will cause the COMMAND line to change to STU-C
C and the appropriate EOC message will be sent. The STATUS
line will report either WAITING, FAILED, SUCCESS, or ILLEGAL
ACTION.
STU-R N (F3): Use this to loopback the STU-R, facing the net-
work. This will cause the COMMAND line to change to STU-R
N and the appropriate EOC message will be sent. The STATUS
line will report either WAITING, FAILED, SUCCESS, or ILLEGAL
ACTION.
4W STU-R<
STU-R
Page 13 of 101