Entering A User Id/Password - VeEX MTT-14B User Manual

MTT-14B e_Manual D07-00-083P RevA00
LOCAL IP
Enter a local IP address of the circuit under test. For LLC-BRG
and LLC-RTE STATIC, this is the local IP address used. For
LLC-BRG DYNAMIC mode, there is no LOCAL IP mode since a
dynamically assigned local IP address is used.
DESTINATION IP
Enter the destination address of the device to be pinged. If ping-
ing a gateway, enter the gateway's address for the Destination
IP. Pinging the gateway verifies connectivity to the ISP.
USER ID
For authentication (PAP and CHAP), enter a user ID prior to receiv-
ing an IP address from the ISP. Refer to Section 2.2.4.3.1.
PASSWORD
For authentication (PAP and CHAP), enter a password prior to re-
ceiving an IP address from the ISP. Refer to Section 2.2.4.3.1.

2.2.4.3.1 Entering a User ID/Password

Follow this procedure to enter a USER ID or PASSWORD for PAP
and CHAP authentication.
1. Place the cursor on USER ID.
2. Press EDIT (F1) and a character screen is displayed.
3. Press INPUT (F3) to enter the character grid. Notice a cursor
appears in the grid and INPUT changes to STOP.
4. Use to move the cursor to the desired character.
Press ENTER to select that character. The character will ap-
pear on the USER ID line.
5. Continue selecting characters until done. Press STOP (F3) to
exit the character grid.
• If you make a mistake; press STOP (F3). Use
the incorrect character.
- Press DELETE (F2) to delete the character.
- Press INSERT (F1) to add a character to the left of the
selected character.
- Press OVER (F1) to replace the selected character with a
new character.
6. Select HIDE USER ID (or PASSWORD) and choose whether
to hide the ID code by pressing YES (F1) or NO (F2). Figure
13 shows the USER ID and PASSWORD hidden.
7. Press F4 to save the ID and return to the setup screen.
8. Select PASSWORD and follow the previous procedure from
step 2 to enter the password.
to select
Page 23 of 101