Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
USER ID (not in LLC-BRG, LLC-RTE, or CLIPoA modes)
For authentication (PAP and CHAP), enter a user ID prior to re-
ceiving an IP address from the ISP. See the following subsection
entitled Entering a User ID/Password.
PASSWORD (not in LLC-BRG, LLC-RTE, or CLIPoA modes)
For authentication (PAP and CHAP), enter a password prior to
receiving an IP address from the ISP. See the following subsec-
tion entitled Entering a User ID/Password.
When finished configuring the IP CONFIGURATION screen, press
F3 to connect.
Entering a User ID/Password
1. Place the cursor on USER ID.
2. Press EDIT (F1) and the character entry screen is displayed.
3. Press INPUT (F3) and a cursor appears in the grid.
4. Use
to move the cursor to the desired character.
Press ENTER to select that character. The character will ap-
pear in the USER ID line.
5. Continue selecting characters until done. Press STOP (F3) to
exit the character grid. If a mistake is made; press STOP (F3)
and use
to select the incorrect character.
• Press DELETE (F2) to delete the character.
• Press INSERT (F1) to add a character to the left of a se-
lected character.
• Press OVER (F1) to replace the selected character.
6. At HIDE USER ID, choose whether to hide the ID code by
pressing YES (F1) or NO (F2). In the bottom left screen shown
in Figure 20 the USER ID and PASSWORD are hidden.
7. Press SAVE (F4) to save the ID and return to the Setup
screen.
8. Select PASSWORD and follow the previous procedure.
Page 38 of 101
Advertisement
Table of Contents
